The optimal design of the injection molding
Dalian injection moldingFactory specializing in the production ofElectric tool partsParts, medical equipment, electronics components and home appliance parts, etc.Injection molding process can be roughly divided into the following six stages:
Clamping, glue, pressure maintaining and cooling, mould and products.
The above process again and again, can batch periodically to produce products.Thermosetting plastic and rubber molding including the same process, but a thermoplastic material barrel temperature is low, the injection pressure is higher, the mould is heated, finished material injection in the mold of the subject to curing or curing process, and then strike off membrane.
意甲下注The optimal design of the injection molding
Low mold installation, debugging and maintenance
意甲下注When pouring system (gate, flow channel, cold slug well, etc.) optimization design
Low cooling system (water, water, beryllium tube, etc.) to optimize the design
Low gating system, cooling system, the relationship between the mould structure and injection molding process
意甲下注Low injection mold structure, composition, classification and function;
意甲下注When using CAE mold flow analysis technology mold optimization design
意甲下注The setting and adjustment of low shrinkage
The trend of the current processing technology is developing towards the direction of the high and new technology, these technologies include: micro injection molding, high filling compound injection, water injection, mixed with a variety of special injectionMolding process, foam injection molding, mold technology, simulation technology, etc.